Compool Cp3810, Инструкция по установке и эксплуатации

Страница: 17 / 43

15
Compool Cp3810
making connections, cut off stripped ends of cable. Insert the 2 wires to be connected into
the connector and squeeze the connector with pliers. Two extra connectors are included.
Caution Do not strip wires.
4. At the Power Center circuit board, connect sensor wires to FRZ SENS screw terminals.
Pay attention to color-coding of wires.
5. Adjust the Freeze program switch at the bottom of the Power Center circuit board to
determine which pumps should turn on during freeze protection.
Note Calibration of Freeze Temperature Sensor is required. See Calibration for details.
Control Panel
• To install the Control Panel
1. Select a location inside the house or other weather-protected area to mount the Control
Panel. The Control Panel should be installed at or below eye level.
2. Remove backplate from Control Panel. Position backplate and mark the three mounting
points.
3. Drill 3/16” diameter holes at the three points. Insert mounting anchors (included) into the
three holes.
4. Pull cable through large hole in backplate, use the three 1.25” screws to mount backplate
to wall. Use crimping tool to connect modular connector to cable. See Modular Crimping
Tool for details.
5. Plug modular connector into either COM PORT socket on the back of the Control Panel.
6. Use the four 1/2” screws (included) to mount the Control Panel to the backplate.
7. At the Power Center, use the crimping tool to connect the modular connector to the cable.
Plug modular connector into the COM PORT socket.