Compliance West MegaPulse, Инструкция по эксплуатации

Страница: 12 / 20

12
Fuse Replacement
There is a user-replaceable fuse (F1) located on the rear panel of the instrument. It is located
behind a door in the Power Inlet-Power Switch-Fuse Holder device. The fuse rating is noted on
the rear panel, and also listed in the Specifications section of this manual. Do not attempt to
replace it with a fuse of any other rating.
Use the following procedure to replace the fuse F1:
1.
Turn the power switch to the O or off position.
2. Unplug the instrument from the source of supply.
3. Remove the power inlet cord from the instrument.
4. Using a small screwdriver, pry open the fuse holder door.
5. Replace the fuse with a new one of the correct rating.
6. Replace the fuse holder door and power inlet cord.
Front and Rear Panel Features
Before using your tester, take a few minutes to become familiar with the use of its controls,
indicators and connectors. The front panel features of the MegaPulse are shown in Figure 3 and
described in Table 1. The rear panel features of the MegaPulse are shown in Figure 4 and
described in Table 2.