Complete Control MRZ-260 - AUTRE, Руководство по установке

Страница: 12 / 20

MRZ-260 B
ASE
S
TATION
Page 9
If you look at the column for IR output, you can see that the default
sends IR commands for all devices to ALL of the IR outputs. Both
options must be changed for identical components.
3. Adjust the Signal For Each of the Identical Devices
The RF Setup window enables you to adjust the Signal output for
each device individually, by clicking on the intersection of a row
and a column and then selecting RF from the two options shown in
the pull down list box.
Select RF from the two options shown for EACH of the identical
TVs. You may leave the other components of the system set to IR
& RF.
4. Adjust the Flashers For Each of the Identical Devices
The RF Setup window enables you to adjust which Flashers output
by the remote control for each device individually, by clicking on
the intersection of a row and a column and then selecting
1-4 from
the five options shown in the pull down list box.
Select the correct Flasher (refer to your connection notes) for
EACH of the identical TVs. You may leave the other components of
the system set to ALL.
See figure on the next page.
In the figure below, each device is set to a specific flasher.
5. Close the RF window and Download to the Remote.