Compass RALLYE, Руководство пользователя

Страница: 65 / 134

8-30
HOW TO USE YOUR CARAVAN’S EQUIPMENT
safety catch. Close the access door and
lock it. Your Thetford toilet is now ready
to use.
CAUTION: Never use force if you cannot get
the tank back into place easily. This may
cause serious damage. If blockage occurs,
always check if the blade handle is in the
correct (closed) position.
7. For toilets with own Flush-Water Tank:
Open the water filling door and fill the
flush-water tank with the correct dosage
of Aqua Rinse. This Thetford toilet fluid
keeps the flush water fresh and improves
the flushing. Next, fill up the flush-water
tank with clean water (approximately 8
litres) using a ferry can or hose. Your
toilet is now ready to use.
Preparing for use with Optional
Features
8. Automatic Ventilator: Open the access
door on the outside of your caravan and
remove the Waste Holding Tank (as
described above).
9. Remove the filter housing cover and if no
filter is present, place a new filter into the
filter housing. Peel off the sticker lids on
the filter. Place back the cover of the filter
housing.
Using the toilet (standard)
10. Turn the bowl to the desired position with
the lid closed and using both hands.
11. To activate the control panel, press the
flush-button once. The control panel
display will stay activated for
approximately 5 minutes. Run some
water into the bowl by pressing the flush
button again briefly.
12. The toilet may be used with the blade
open or closed. To open the blade, slide
the blade handle under the toilet bowl
sideways. After use, open the blade (if
still closed) and flush the toilet by
pressing the flush button for several
seconds (if necessary re-activate the
control panel). Close the blade after use.
CAUTION: If your toilet has its own
flush-water tank, please make sure that you
do not travel with a flush-water tank that is
too full. Do not travel with water in the toilet
bowl. Failure to adhere to this notice may
result in water damage to your caravan.
Using the toilet with Optional
Features
13. Electric Blade: Push the electric blade
button on the control display to
electrically open or close the blade. In the
case of failure, you can manually open or
close the blade by sliding the small
handle under the toilet bowl sideways.
14. Automatic Ventilator: The ventilator
automatically starts when the control
panel is activated (by pressing the flush
button) and will automatically shut off
after approximately 5 minutes. The
Automatic Ventilator Indicator will flash
until automatic shut-off occurs. If you
want to stop the ventilator, press the
Automatic Ventilator button. If you want
to re-start the ventilator, press the button
again (the LED will start flashing again).
15. Flush Water Tank Level Indicator (only for
toilets with own flush-water tank): When
the Flush Water Tank Level Indicator
lights up, refill the flush-water tank, as
only about 1.5 litres of water is left in the
tank, which is sufficient for approximately
2 flushes.
Emptying
The Waste Holding Tank has a capacity of 18
litres and requires emptying when the red
light (LED) on the toilet control display lights
up, when the Waste Holding Tank only has
capacity for approximately 2 more litres,
which is no more than two to three further
uses.
Make sure that the blade is closed. Open the
access door located outside the vehicle, pull
the safety catch upwards and remove the
Waste Holding Tank.
16. Place the Waste Holding Tank in an
upright position (Pull-Out Handle at the
top, Wheels at the bottom). Slide the
handle sideways - to the front of the tank
- until it snaps out of its locked position.
17. Pull the handle up and wheel the Waste
Holding Tank to an authorised waste
disposal point.