Compass RALLYE, Руководство пользователя

Страница: 59 / 134

8-24
HOW TO USE YOUR CARAVAN’S EQUIPMENT
BATTERY CHARGER
The battery charger for the caravan battery
will automatically switch on when the caravan
is connected to a mains supply. The battery
charger will also provide a 12V supply to the
caravan when a battery is not connected.
Please note that the battery charger fitted is
designed to keep your battery charged and is
not designed for charging up a flat battery.
Smoke Alarm
Operation
The smoke alarm is operating once a fresh
battery is installed and testing is complete.
When products of combustion are sensed,
the unit sounds a loud 85db pulsating alarm
until the air is cleared.
Hush Control - The “HUSH” feature has the
capability of temporarily desensitising the
alarm circuit for approximately 8 minutes.
This feature is to be used only when a known
alarm condition, such as smoke from cooking
activates the alarm. If the smoke is not too
dense, the alarm will silence immediately and
the Red LED will flash once every 10
seconds for approximately 8 minutes. This
indicates that the alarm is in a temporarily
desensitised condition. The smoke alarm will
automatically reset after approximately 8
minutes and sound the alarm if particles of
combustion are still present. The “HUSH”
feature can be used repeatedly until the air
has been cleared of the condition causing the
alarm.
Note: Dense smoke will override the hush
control feature and sound a continuous
alarm.
CAUTION: Before using the alarm hush
feature, identify the source of the smoke and
be certain a safe condition exists.
Flashing LED Light - This smoke alarm is
equipped with a flashing red indicator light.
The light is located under the test button and
will flash every 40 seconds to indicate that
the smoke alarm is receiving power.
Testing - Test by pushing the test button on
the cover and holding it down for a minimum
of 5 seconds. This will sound the alarm if the
electronic circuitry, horn and battery are
working. If no alarm sounds, the unit has
defective batteries or other failure. DO NOT
use an open flame to test your alarm, you
could damage the alarm or ignite combustible
materials and start a structure fire.
Wattage Output Chart
The power level is set by pushing the Power button. The chart shows the display, the
power level and the percentage of power.
Push the Power button Power level (Display) Approximate Percentage of Power
once P-HI 100%
twice P-90 90%
3 times P-80 80%
4 times P-70 70%
5 times P-60 60%
6 times P-50 50%
7 times P-40 40%
8 times P-30 30%
9 times P-20 20%
10 times P-10 10%
11 times P-00 0%