- The power supply voltage of the power source should be 220 VAC +/- 10% or 127 VAC +/- 10%, too low a supply
voltage may cause erratic welding operation, too high a supply voltage may cause overheating of the components and
possible damage to the equipment.
3-8. CONNECTION AS AN INDEPENDENT WELDING POWER SOURCE.
CAUTION
3-9. SUPPLY VOLTAGE AT 127 V a.c.
CAUTION
THE EQUIPMENT MUST BE CONNECTED TO THE MAINS SUPPLY IN COMPLIANCE WITH
SAFETY STANDARDS AND IN CONDITIONS THAT DO NOT EXPOSE THE USER TO RISKS OR
VOLTAGE DISCHARGES. MUST ALWAYS BE GROUNDED WHEN USING THIS PRODUCT.
127 V, 20 A
127 V, 15 A
Unplug the power cord with plug from the 220V
receptacle located inside the side box. Use the
adapter provided to connect to 127V power
voltage.
3-7.CONNECTION OF THE WELDING POWER SOURCE TO THE ENGINE-
GENERATOR.
The power supply is factory connected to the engine-
generator by means of a half turn plug in the 250 V, 20 A.
receptacle located in the side box of the chassis, see
pictur e.
CAUTION
Detail of the power connection to the
motor-generator.
CAUTION
8
SEE SAFETY SIGNAL AT THE BEGINING THIS
M A N U A L
SEE SAFETY SIGNAL AT THE BEGINING THIS
M A N U A L
SEE SAFETY SIGNAL AT THE BEGINING THIS
M A N U A L
