. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2-19
Installation of ProLiant Storage System /U
Compaq ProLiant Storage System /U User Guide
6. Locate the SCSI controllers and verify that the installed drives
are displayed.
7. If you are using a Compaq SMART SCSI Array Controller or a
SMART-2 Array Controller Family Product, you should verify the
logical drive configuration, paying special attention to the selected fault
tolerance method. For this configuration information, refer to:
❏
the README files for Release Notes for Compaq supplied
operating systems
❏
your software documentation for other operating systems
❏
the documentation supplied with your Compaq array controller
8. Select
Save the configuration and exit.
The utility will configure your system to recognize any new controllers and
devices. Reboot your system normally to begin using the added disk space on
the storage system.
From Diskette
Use these instructions to run the Compaq System Configuration Utility if
your server:
■
has not had this utility previously installed on the boot drive, and
■
does not have a bootable CD-ROM drive
To create and use System Configuration Utility diskettes from the SmartStart
and Support Software CD included with the ProLiant Storage System /U:
1. Insert the SmartStart and Support Software CD with the
system running.
2. Run the \DSKBLDR\DSKBLDR.EXE file from a Windows 95 or
Windows NT system. In some systems, the Diskette Builder utility will
start automatically.
3. Select
Create software diskettes from CD only.
4. Select
(check)
Compaq System Configuration Utility.
