. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2-18
Installation of ProLiant Storage System /U
Compaq ProLiant Storage System /U User Guide
5. Select
View or edit details.
6. Locate the SCSI controllers and verify that the installed drives
are displayed.
7. If you are using a Compaq SMART SCSI Array Controller or a
SMART-2 Array Controller Family Product, you should verify the
logical drive configuration, paying special attention to the selected fault
tolerance method. For this configuration information, refer to:
❏
the README files for Release Notes for Compaq supplied
operating systems
❏
your software documentation for other operating systems
❏
the documentation supplied with your Compaq array controller
8. Select
Save the configuration and exit.
The utility will configure your system to recognize any new controllers and
devices. Reboot your system normally to begin using the added disk space on
the storage system.
From CD
Use these instructions to run the Compaq System Configuration Utility if your
server:
■
has not had this utility previously installed on the boot drive, and
■
has a bootable CD-ROM drive
To run the System Configuration Utility directly from the SmartStart and
Support Software CD included with the ProLiant Storage System /U:
1. Be sure all new drives are in place and the storage system is turned ON.
2. Boot the server from the CD.
3. Select
Run System Configuration Utility.
4. Select
Review hardware settings.
5. Select
View or edit details.
