17
DAILY MAINTENANCE
REPLACING THE DUST FILTER
11.
Detach suction connector (1), pull out suction tube (2), remove fastening belt (3), pull out
suction unit(4).
WARNING!
Use gloves when doing this to protect yourself against contact
with dangerous liquids.
12.
Loosen the hooks on drum (7).
13.
Remove head (8).
14.
Replace paper filter (9).
15.
Put the head back in and fasten it onto the drum with its hooks. Put the suction unit back
in its compartment, insert the flexible tube in the nozzle and then reattach the connector.
16.
Clean the drum. Do not leave dust in the drum for long time periods.
17.
Dismantle the brushes and clean them with a jet of air (to dismantle the brushes refer to
the section “DISMANTLING THE BRUSH”).
REMOVING THE PAD DISK
1.
Connect the battery connector if it is not connected
2.
Turn the key to position “1”
3.
Use the control switch to lift the base (if it isn't already lifted)
4.
Turn the key to “0” and pull it out from the dashboard (hand injuries may be caused if the
brush is removed with power on)
WARNING!
Make sure there are no objects or persons in the vicinity of the
brush when doing this.
3
1
2
4
6.
Keep the base in its raised position. Unscrew ring (1) (rotating counterclockwise),
remove pad (2) from the drive disk, retighten the disk fastening ring (rotating clockwise).
WARNING!
Wear gloves when doing this to protect yourself against possible
contact with dangerous materials and liquids.
2
1
3
4
7
8
9
1
2
