12
PREPARING THE MACHINE
9.
CONNECTING THE BATTERY CONNECTOR
Battery connector (1) must be connected to machine connector (2)
10.
BATTERY CHARGE LEVEL GAUGE
The battery charge level gauge is a digital unit with 4 fixed and one flashing position. The
numbers on the display give an approximate idea of the state of charge:
4
= maximum charge,
3
= 3/4 charge,
2
= 2/4 charge,
1
= 1/4 charge,
0
= batteries
discharged (flashing)
WARNING!
The pad motor automatically turns off a few seconds after the
flashing “0” appears. The remaining charge can be used to move the
machine to the recharging point.
11.
INSTALLING THE PAD
1.
Connect the battery connector
2.
Turn the key to "1"
3.
Operate the lever to lift the base
4.
Turn the key to "0" and pull it out from the dashboard
WARNING!
Make sure no persons or objects are in the vicinity of the pad
base when doing this.
3
1
2
4
5.
Keep the base in its raised position. Unscrew (rotating counterclockwise) ring (1).
Install pad (2) on the disk drive plate. Use one hand to support the pad and the other to
tighten the fastening ring (rotating it clockwise).
WARNING!
Wear suitable safety gloves before installing the pad.
1
2
1
2
