Comnet RLMCSFP Series, Инструкция по установке и эксплуатации

Страница: 5 / 6

TECH SUPPORT: 1.888.678.9427
INSTALLATION AND OPERATION MANUAL RLMCSFP SERIES
INS_RLMCSFP_REV–
Rev. 18 Sep 2020 PAGE 5
INSTALLATION AND OPERATION MANUAL RLMCSFP SERIES
7 - CONNECT POWER
Connect power to unit per the following table.
Table 3 – Power Connections per Use Case
RLMCSFP24DC RLMCSFP48DC RLMCSFPHV RLMCSFPPOEHO
Operating Voltage
Redundant Inputs
9 to 36 VDC (max)
Redundant Inputs
36 to 59 VDC (max)
88 to 300 VDC (max)
OR
85 to 264 VAC (max)
Redundant Inputs
44 to 57 VDC (max)
Use Power Connectors
Vin1+ and Vin1- for PS 1
Vin2+ and VIN2- for PS 2
Vin1+ and Vin1- for PS 1
Vin2+ and VIN2- for PS 2
+/L, -/N,
and Earth GND
Vin1+ and Vin1- for PS 1
Vin2+ and VIN2- for PS 2
Contact the ComNet Design Center, or refer to the appropriate installation and operation manual when configuring and specifying power for a deployment.
8 - VERIFY FUNCTIONALITY
See LED Indicator table below and Troubleshooting Guide if corrective action is needed.
Table 4 – Front Panel LED Indicators
SFP Link SFP Speed Fault Power PoE
GREEN Solid Communication link has been established
over optical fiber. Flashes when data is
being transmitted.
1000 Mbps No Fault (NC-
COM)
Power Applied –
Flashing Fiber failure or copper failure (Link Fault
Enable must be switched set to ON)
– – – –
Dim – – – – 30 W Mode
Bright – – – – 60 W Mode
RED Solid – 100 Mbps Fault (NO-COM) – -
OFF Communication link has not been
established.
Unit is not correctly powered up or DIP
Switch incorrectly set.
(Reset power after switch change.)
Unit is not
correctly
powered up
Unit is not
correctly
powered up
-
Figure 5
–
Electrical Port
Ethernet
Speed
Ethernet
Link /
Activity
Installation Instructions (Continued)
Figure 6 - Fault Relay Operation
The fault relay is normally closed and will open on any of the following alarm conditions:
- Link Fault is enabled on the
remote RLMCSFP unit and the corresponding copper port has been
disconnected.
- Link Fault is enabled on the local RLMCSFP unit and the corresponding copper port has been
disconnected.
- Fiber Fault is enabled on the local RLMCSFP unit and the fiber link is down or the power has been lost to
either the local or remote RLMCSFP unit.
Table 5 – Electrical Port LED Indicators
Link / Activity Speed
GREEN Solid
Communication link has been established over the electrical cable –
Flashing Data is being transmitted over the electrical cable –
YELLOW – 1000 Mbps Speed
OFF Communication link has not been established. 10/100 Mbps Speed