Comnet Netwave NWKSP1, Инструкция по установке и эксплуатации

Страница: 11 / 20

INS_NWKSP1_REV– 07/10/14 PAGE 11
INSTALLATION AND OPERATION MANUAL NWKSP1
TECH SUPPORT: 1.888.678.9427
Solar Panel Electrical Wiring
Assemble The Solar Panels and run cable thru the cable glands on the bottom of the enclosure.
Do not connect PV cables to the controller yet, it is recommended to connect the battery first.
Enclosure Mounted to Pole with Clamps
Connect the 15' PV cable with MC4 female connector to the positive male connector on the solar
panel and feed the open end of the cable thru the enclosure.
Connect the 15' PV cable with MC4 male connector to the negative female connector on the solar
panel and feed the open end of the cable thru the enclosure.
Note: The cables may ship as one 30' cable. If this is the case, you will need to cut the cable in
half creating two 15' cables.
Please reapply the Twist Nut to the open end of the cables to prevent a short.
15' MC4 Male and MC4 Female Cables