Community Wet II, Руководство по эксплуатации и установке

Страница: 28 / 40

Community WET II - Operation and Installation Manual - Page 28
SSY25KIT Mounting Kit for W2-112 and W2-312
An optional mounting bracket kit (model SSY25KIT) is available for the W2-112 and W2-312 loudspeakers. It
is sold separately. The SSY25KIT is designed to mount a W2-112 or W2-312 loudspeaker in either a vertical or
horizontal orientation, providing precise acoustic focusing. The SSY25KIT consists of a yoke mounting
bracket and two adapter plates, constructed of powder-coated stainless steel.
The yoke bracket is fitted with a series of mounting holes that allow the installer to vary the distance from
the enclosure to the mounting surface in order to suit the requirements of the installation. It is engineered
to provide a high margin of safety when supporting a W2-112 or W2-312 loudspeaker.
All hardware required to attach the SSY25KIT to the loudspeaker enclosure is included in the kit. No
additional hardware is provided to attach the yoke bracket to the mounting surface. Such hardware must be
supplied by the installer and should be sized and rated for the weight load of the enclosure, keeping in mind
that additional torque load may occur when focusing the loudspeaker within the yoke assembly. The
installer is solely responsible for determining if the mounting surface is capable of safely supporting the
weight load of the loudspeaker and bracket, and for selecting appropriate hardware to install it.
DANGER:
All rigging fittings must be fitted with either optional mounting hardware or they must remain
sealed with the fasteners that come installed in the enclosure. These fasteners attach to internal steel
rigging brackets, thereby providing structural integrity. Without these fasteners, the structural integrity of
the enclosure would rely solely on the enclosure material and bonded joints, which over time could
deteriorate. Therefore,
all rigging fittings must have fasteners in place
so that the enclosure may be
safely ‘flown’ or suspended overhead.
Additionally, if the rigging fittings are not sealed, air leaks will occur in the enclosure that will
compromise the low frequency performance with distortion and reduced output.
WARNING:
WET II loudspeaker rigging fittings are rated at a Working Load Limit of 150 lbs (68 kg) with
a 15:1 safety margin. No single rigging fitting should ever be subjected to a load that is greater than 150
lbs. Failure to heed this warning could result in injury or death!
Figure 8 - SSY25KIT Dimensions
SSY25KIT Yoke Bracket