Page 4
BalancePoint™ Flyware
I SERIES
Rigid Mount Subwoofer Installation IS6/IS8
Figure 3.
Rear Wall or Ceiling Mount: Remove middle and
rear center cabinet bolts and attach yoke to cabinet
5
Fully tighten
all
connections
4
APPLICATION:
Suspend and aim single Subwoofers in outward facing or down
fire applications.
Before assembly:
Adhere the large rubber washers to the inside of the yoke
(aligned with cabinet mounting point). Adhere the smaller 1/4" ID washers to
the cabinet over the 6mm holes.
Note:
The yoke can be attached to the building structure and then the
loudspeaker can be installed later.
U-BRACKETS
Figure 4.
Down Fire Mount: Remove middle and front
center cabinet bolts and attach yoke to cabinet
(Block the small 6mm hole with HW.25 washer to seal it)
3
HW1
HL1
HH1-4
HW8-4
UB
HW6
HS6
HW.25
HL6
Alternative Down Fire
Mounting for larger models
- use (2) yokes and mount
to forward mounting
points - arrows.
UB
HW.25
HW1
HL1
HH1-4
HW8-4
Rotatable / Pivot for
wall or pole mount
Max rotation of yoke:
IS6/8-212 = 35°
IS6/8-218 = 45°
Rigid Wall or Ceiling
Mount: Center and
rear center points on
each end
Rigid Down Fire
Mount: Center and
front center points
on each end
