ADCP-93-103 • Issue 3 • November 2016
Page 6
© 2017
CommScope
. All Rights Reserved.
1.5
Specifications
Table 1
lists specifications for the LSX combination panel.
Table 1. LSX Combination Termination/Splice panel Specifications
ITEM
DESCRIPTION
Dimensions (HxWxD)
15 x 23 x 15 in. (27.9 x 58.4 x 38.1cm)
Rack Mount
Mounts in 23-inch rack
Weight (unloaded)
10 pounds (4.5 kg)
Terminations
288 terminations
Connector type
SC or LC
Pre-installed pigtails
Ribbon or straned IFC
Splice tray capacity
Six splice trays
Splice chips
Mass fusion or heatshrink fusion
2
UNPACKING THE PRODUCT
Unpack and inspect the LSX combination panel as follows:
1. Inspect the exterior of the shipping container for evidence of rough handling that may have
damaged the contents of the container.
2. If damage is detected or if parts are missing, file a claim with the commercial carrier and
then notify ADC Customer Service. Save the damaged carton for inspection by the carrier.
Note: For information on how to contact ADC, if needed, see
Section 5 on Page 18
.
3. Save the shipping container for use in case the equipment requires shipment at a future
date.
3
INSTALLATION
The main steps in installing an LSX panel are: mounting the panel on the frame, breaking out
the cable to be spliced within the panel, installing the cable on the outside of the panel using the
ADC-provided cable clamp, and routing the cable within the panel from the cable clamp to the
splice deck. For instructions, refer to the following subsections.
3.1
Mounting the Panel on the Frame
Install the panel from the front side of the rack, using the following procedure. Refer to
Figure 6
.
