3
3.2.6 Place the cable in the groove and route the aramid strength
member through the left groove (1) and lead behind the back (2) over
the hinging part (3) to the front. Wrap 1 x over the hinging part (3) and
bring back to the front. Keep the aramid strength member under tension
and close the hinging part (4). Apply some tension to the aramid
strength member without pulling at the cable ! Cut away the remaining
strands.
1
2
3
4
3.2.7 Pull back the cable and install the mini termination unit in the
holder. Secure with the O-ring.
3.2.8 Tighten the trigger till it buts up with the flange (locking system).
3.2.9
Optional
: apply some foam to the cable and secure with tie-
wrap to the frame.
