2
3.2.2 Open the port. The cutting wire can be used. Make sure edges
are free of burrs. Install the seal in the port, marking line always facing
forward. Tighten the 2 screws. Make sure the screws grip in the port.
3.2.3 Install the metal bracket at the corresponding port. Fix with
screw.
Note: in order to have a good cable management, make sure all
cables have the same length !
3.2.5 Mark the drop cable just below the metal bracket and pull a bit
further. Remove the outer cable jacket (2.2m) and install mini termination
unit as shown.
Note
: maximum cable diameter to be used in mini termination unit is
2.1 mm.
3.2.4 Feed the drop cable through the port. Respect cable lengths.
3.2.1 Before installing the gel seal in the port, install the 2 fixation
screws and all blind plugs.
3.2
FIST-GCO2-BX6
