466
(18.3")
466
(18.3")
44
(1.7")
(Continued from page 3)
(continued on page 5)
(Note: These instructions are for 457 mm (18 inch) wide antennas. For 350 mm (14 inch) wide antennas, see page 3.
Step 1 (457 mm): Hand tighten the linkage bracket (item 9) onto plate bracket (Item 8) using M10 screws, lock washers, flat
washer and nuts (Items 11, 12, 14 &13). The direction of linkage brackets (item 9) is different for the 350 mm wide antennas.
MOUNT ASSEMBLY FOR
457mm (18.0") WIDE ANTENNAS
Step 2: Keep the antenna parallel.
(1) Assemble an antenna on the middle linkage bracket (Item 9) using M10 screws, lock washers, flat
washers and nuts (Items 11, 12, 14 &13). Hand tighten these nuts (Item 13).
See sequence 1.
(2) Assemble the antenna on the side linkage bracket (Item 9) using M10 screws, lock washers, flat
washers and nuts (Items 11, 12, 14 &13). Hand tighten these nuts (Item 13).
See sequence 2.
(3) Repeat the sequences 1 & 2 to install another antenna.
(4) Keep antenna with plate (Item 8) parallel. Then fully tighten all nuts.
After top bracket plate is installed, repeat step 2 for the bottom bracket plate and middle bracket plate.
When brackets properly installed the gap between antenna and caps should be 44 mm (1.7") as shown.
Hand tighten the linkage bracket.
Hand tighten the linkage bracket.
Fully tighten the linkage brackets.
14
12
13
11 12 13 14
8
11
Antenna
Antenna
Sequence 1
13
12
14
11
9
8
14
8
9
Sequence 2
Sequence 3
13
12
11
9
MOUNT ASSEMBLY FOR
457mm (18.0") WIDE ANTENNAS
BOLT DIAMETER
TORQUE
M10
37 N.m (27 ft. lbs)
466
(18.3")
466
(18.3")
44
(1.7")
639848
Page 4 of 13
www.commscope.com
© 2019 CommScope, Inc. All rights reserved.
Visit our website at www.commscope.com or contact your local CommScope representative or BusinessPartner for more information.
All trademarks identified by ® or ™ are registered trademarks or trademarks, respectively, of CommScope, Inc. 639848 E (08/19)
466
(18.3")
466
(18.3")
44
(1.7")
