357
（14.1"）
42
（1.65"）
357
（14.1"）
(Continued from page 2)
(continued on page 4)
(Note: These instructions are for 350 mm (14 inch) wide antennas. For 457 mm (18 inch) wide antennas, see page 4.
Step 1 (350 mm): Hand tighten the linkage bracket (ITEM 9) onto plate bracket (Item 8) using M10 screws, lock washers, flat washer
and nuts (Items 11, 12, 14 &13). The direction of linkage brackets (Item 9) is different for 457mm wide antennas.
MOUNT ASSEMBLY FOR
350mm (13.8") WIDE ANTENNAS
Hand tighten the linkage bracket.
Step 2: Keep the antenna parallel.I
(1) Assemble an antenna on the middle linkage bracket (Item 9) using M10 screws, lock washers, flat
washers and nuts (Items 11, 12, 14 &13). Hand tighten these nuts (Item 13).
See sequence 1.
(2) Assemble the antenna on the side linkage bracket (Item 9) using M10 screws, lock washers, flat
washers and nuts (Items 11, 12, 14 &13). Hand tighten these nuts (Item 13).
See sequence 2.
(3) Repeat the sequences 1 & 2 to install another antenna.
(4) Fully tighten all nuts.
After top bracket plate is installed, repeat step 2 for the bottom bracket plate.
W
hen brackets properly installed the gap between antenna and caps should be 42 mm（1.65 "） as shown.
Fully tighten the linkage brackets.
Hand tighten the linkage bracket.
11
8
12
13
14
11
Sequence 2
Sequence 3
Sequence 1
9
8
11
12
14
13
11
8
Antenna
Antenna
12 13 14
12 13 14
MOUNT ASSEMBLY FOR
350mm (13.8") WIDE ANTENNAS
9
BOLT DIAMETER
TORQUE
M10
37 N.m（ 27 ft. lbs）
357
（14.1"）
42
（1.65"）
357
（14.1"）
639848
Page 3 of 13
www.commscope.com
© 2019 CommScope, Inc. All rights reserved.
Visit our website at www.commscope.com or contact your local CommScope representative or BusinessPartner for more information.
All trademarks identified by ® or ™ are registered trademarks or trademarks, respectively, of CommScope, Inc. 639848 E (08/19)
