SB6183 connection diagram
1. Check that a coaxial cable is already connected to a cable wall outlet or RF splitter (not
included).
2. Connect the other end of the coaxial cable to the Cable connector on the rear of the
SB6183.
Use your hand to tighten the connectors to avoid damaging them.
3. Connect the Ethernet cable to the Ethernet port on the rear of the SB6183.
4. Connect the other end of the Ethernet cable to the Ethernet port on your computer.
5. Connect the power cord to the Power port on the rear of the SB6183.
6. Plug the other end of the power cord into an electrical wall outlet that is not controlled
by a wall switch.
Note: This automatically powers ON the SB6183.
Establish an Internet connection
Although your computer may already be configured to automatically access the Internet,
you should still perform the following cable modem connectivity test to check that your
devices were connected properly:
1. Power ON the computer connected to the SB6183, if it is turned off, and then log in.
2. Contact your service provider to activate (provision) the SB6183. You may have to
provide the HFC MAC ID listed on the cable modem label.
Note: Your service provider may allow for automatic activation which will
automatically launch their special website when you open a web browser.
3. After the SB6183 is provisioned (or activated), open a web browser (such as Internet
Explorer, Google Chrome, Firefox, or Safari) on the computer.
4. Type a valid URL (such as www.surfboard.com) in the address bar and then press Enter.
The ARRIS website should open. If it fails to open, please contact your service provider
for assistance.
Chapter 3: Installing your SB6183
SURFboard
®
SB6183 DOCSIS
®
3.0 Cable Modem User Guide STANDARD Revision x.4
14
