6
GENERAL SAFETY INSTRUCTIONS (cont.)
e) Maintain power tools.
Check for misalignment or binding of moving parts, breakage of parts and
any other condition that may affect the power tools operation. If damaged, have the power tool
repaired before use. Many accidents are caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc., in accordance with these instructions and
in the manner intended for the particular type of power tool, taking into account the working
conditions and the work to be performed.
Use of the power tool for operations different from
intended could result in a hazardous situation.
5) SERVICE
a) Have your power tool serviced by a qualified repair person using only identical
replacement parts.
This will ensure that the safety of the power tool is maintained.
ADDITIONAL SAFETY INSTRUCTIONS FOR PUMPS
CAUTION:
Not intended for cleaning and other maintenance of swimming pools.
CAUTION:
Commercial Electric recommends the power outlet to be used for the water pump, be
protected by a 30mA residual current device or earth leakage circuit breaker.
WARNING!
This product is intended for pumping water in a home domestic application. Do
not use it for corrosive, abrasive, explosive or dangerous liquids. Fluids other than water
will damage the water pump and/or create a fire hazard.
This appliance is not intended for use by person (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
Children should be supervised to ensure that they do not play with the appliance.
• Ensure the water pump is disconnected from mains power when installing.
• Do not install or operate the water pump in an explosive environment or near flammable material.
• Do not operate the water pump without liquid.
• Do not run the water pump dry.
WARNING!
The water pump together with associated pipework operate under pressure. Do
not disconnect water pump or pipework until internal pressure has been released. Failure to
do this could result in personal injury and damage to property.
• Avoid inserting hands into the inlets/outlets of the water pump while it is connected to mains power.
• Before using the water pump, always inspect it visually. Do not use the pump if it is cracked
and/or damaged. If the water pump is damaged, contact Commercial Electric customer service.
• The water pump has a built-in thermal protection overload switch. The water pump stops if an
overload occurs. The motor restarts automatically after it has cooled down.
Never work or perform maintenance on the pump without first making sure it has been disconnected
from the mains power.
Pollution of the liquid could occur due to leakage of lubricants.
IMPORTANT:
Avoid inserting hands into the mouth of the pump if it is connected to the mains.
The electrical connection must always be made in a dry area. Make sure that electrical connections
are protected from inundations.
Protect the plug and the power cable from heat, oil or sharp edges.
If damaged, The power cable must be replaced by a qualified electrician.
!!
!!
