6
Installation (continued)
2
Preparing for mounting the
fixture
Wall Mount
NOTE:
The fixture comes with the wire guard protection
plate (C) already installed on the fixture arm (D).
□
Remove the wire guard protection plate (C)
from the arm (D) of the fixture by loosening
the screws.
□
Mark and pre-drill the three holes on the
desired location of the mounting surface.
Extension Arm Mount
□
Remove the wire guard protection plate (C)
from the arm (D) of the fixture by loosening
the screws.
C
D
3
Mounting the fixture
□
Feed supply wires through the arm (D).
Wall Mount
□
Attach the fixture to the wall using the three
hex head bolts (AA).
NOTE:
Use other suitable bolts or fasteners as applicable
to your mounting surface.
IMPORTANT:
After marking and predrilling the three
mounting holes, partially screw the bottom hex bolts (AA)
and place the fixture’s two bottom mounting grooves onto
the bottom bolt (AA), then insert the top bolt, and tighten all
bolts to firmly secure the fixture to the surface.
IMPORTANT:
Please refer to the below table for using the
correct hardware according to mounting surface material.
Mounting
Surface
Hardware
Brick
1/4 in. Hex head sleeve anchor (not included)
Wood pole 1/4 in. Lag bolts (AA)
Masonry
block
1/4 in. Toggle bolts (not included)
Metal wall
panels
1/4 in. Bolt, nut, washers, and flat backing
plate (not included)
Extension Arm Mount
□
Secure the extension arm to the light fixture arm
(D) using the screws removed earlier.
IMPORTANT:
Extension Arm is available and sold
separately. If you need to purchase the extension arm
please contact your retail store. Installation instructions for
the extension arm are available in the instructions sheet
provided in the extension arm package.
AA
Wall Mount
Extension Arm Mount
D
D
