12
Installation (continued)
4B
Mounting the extension arm
AA
HH
GG
GG
GG
DD
IMPORTANT:
Pay attention to threading the wire through the
center hole in the bolster plate (HH), the pole, the round pole
adapter plate (DD), and the extension arm (AA).
For Square Pole Only:
□
Align the extension arm (AA) holes with the holes drilled on
the pole.
□
Attach the extension arm (AA) by inserting the two hex
head bolts (GG) through the extension (AA), the pole and
the bolster plate (HH), which is inside the pole (fig 1).
□
Tighten the two bolts (GG) to 140 in-lbs (16 Nm).
For Round Pole Only:
□
Use the round pole adapter plate (DD) between the pole
and the extension arm (AA).
□
Insert the two hex head bolts (GG) through the extension
arm (AA), round pole adapter plate (DD), the pole and the
bolster plate (HH), which is placed inside the pole (fig 2).
□
Tighten the two bolts (GG) to 140 in-lbs (16 Nm).
For Direct to Wall:
□
Align the extension arm (AA) holes with the holes pre-
drilled in the wall.
□
Use proper bolts or wall anchors for the type of wall, and
tighten to sufficient torque setting.
□
Consult with a qualified electrician to determine the best
mounting method and bolts for wall mount.
□
Place electrical wires through the center hole in the
extension arm (AA).
CAUTION:
Do not use the bolts included in the hardware
kit for direct to wall mounting (they are intended for pole
mounting). Use bolts or screws and anchors suitable for the
wall’s surface material. Consult with a qualified electrician to
help determine the best mounting method and bolts for wall
mount.
NOTE:
The light fixture has precision Type IV forward throw
optics so when using the extension arm mount keep the
fixture in the 0° position.
