+61 2 9975 6001
5
1.
2.
3.
2
seconds
1
Enter Pre-Programmed Selection mode. See following section.
4
seconds
2
Invoke touch calibration mode - Not covered in this manual. If
entered inadvertently, power cycle the Joey to cancel.
6
seconds
3
Reset to factory defaults.
8
seconds
4
Cancel operation. If you miss your chosen mode, keep holding the
reset button until 4 lights show to avoid doing a factory reset.
3.1 Pre-Programmed Selection
When you enter this mode, four LEDs will light as shown.
The keys will be reassigned to numbers. Enter the 4 digit code shown in the table in
the following and press OK.
The Joey Micro will play a sound for a few seconds while it copies your chosen
application into the working Flash memory area. This overwrites anything that was
already there.
3.2 What The Pre-programmed Applications Will
Do
All but four of the inbuilt applications are intended as standalone projector controllers.