+61 2 9975 6001
3
1 Introduction
The Joey Micro is a range of small programmable control panels that is available in six and
nine button versions. They can be easily programmed for a wide range of AV-related control
tasks using the Windows-based Joey Editor software. Additionally, they come pre-loaded
with a number of commonly-used control programs that may be selected by the installer
without needing a laptop or PC.
2 Installation
The Joey Micro can be fitted to a single-gang mounting block in portrait or landscape
orientation. It can be customised by replacing an underlay sheet that is generated by the
Joey Editor software.
The Joey Micro comes with an Access Port that breaks out its ports to suitable connectors.
The Access Port is connected to the Joey Micro by up to three cables. If your installation
does not need any of the ports served by a specific cable, you do not need to connect that
cable.
Multi I/O 1 (RJ45 patch cable)
Multi I/O 2 (RJ45 patch cable)
Relay Driver (IDC10)
DC power
RS232 2 (bi-directional)
Active low 1
IRBus
RS485
Active low 4
RS232 port 1 (programming)
USB (for firmware upgrade)
Active low 5
RS232 port 2 (projector etc.)
Active low 6
IR ports
+12v
PIR sensor
The Access Port is normally installed in a location convenient to the equipment being
controlled.
Patch cables are not included with the Micro.
