Commax DRC-nSB, Быстрое руководство

Страница: 5 / 10

6 7
1) Press the according button corresponding with the desired residence wished
to be called.
2) After the residence unit answers, conversation with the in-house unit can occur.
3) A “line busy” tone will sound if the residence unit is communicating with another
entrance panel unit.
1) Call duration lasts for 30 seconds.
2) Conversation duration lasts for 60 seconds.
3) If you wish to end a call/conversation, press the Call Button once more.
First set the ID number sequence for the multi-entry unit to “0 ”. After each multi-entry
panel has been installed, the user must program the building distributor's channels to
correspond with each multi-entry units' ID number, 1 to 4.
(CH1
→
ID:1, CH2
→
ID:2, CH3
→
ID:3, CH4
→
ID:4)
If a multi-entry unit's ID is set to “0 ”, then it is in household registration mode.
(If a multi-entry unit's ID is set to “0”, then it is not in normal operation.)
1) On the back of the panel unit, you will find the DIP Switch board.
2) A multi-entry panel using the DIP Switches can be assigned from 1 to 3.
3) When all 4-multi entry panels are installed, Dip switches setting for each
panel is as follows.
This is a video, button-type Multi-Entry unit connected to a building distributor
(CCU-BS) that can support up to 4 Multi-Entry units. It is also connected
to the floor distributor (CCU-FS), also powered by the CCU-BS, which can
connect 4 residences.
2. Part names and Functions 3. Calling In-house unite by resident Number
4. Call / Talk Time Duration
5. Multi-Entry Panel ( ID ) Registration
No.
1
2
3
4
5
6
7
PART NAME PART NAME
C-MIC
CCD Camera Lamp
CDS Sensor
CCD Camera
Speaker
Call Button
Name Card
Camera Angle adjusting knob
Connection terminal for Door Release
Volume control
RS-232 Program Download Terminal
Entry Panel ID setup dipswitch
Connection to terminal to CCU-BS
No.
8
9
10
11
12
13