●
Receiving a calling from visitor
1. When the call button is pressed by a visitor at the door camera, the melody shall be
rung and visitors’ image is shown on the screen.
2. Press “talk” button( ) to talk with a visitor.
(Maximum 60 seconds is available to talk on the phone.)
3. Press “talk” button( ) again to close and return standby mode after finish the
talk.
4. Press “door release” button ( ) to open the door while on the conversation.
●
Communication with a interphone
1. Press "talk" button (
) and "interphone" button(
) in sequence to make a
conversation with the interphone connected with monitor.
(It is available to talk on the phone for Maximum 60 seconds)
2. When receiving a call from an interphone, electrical sound shall be rung.
Press “talk” button ( ) to start to talk.
3. When you receive a call from camera while talking with interphone, Visitor’s image
should be showed on the monitor.
It shall be possible to talk between each unit, monitor, interphone and camera.
Note :
When you finish talking with visitor or interphone, press “talk” button again to
close the talk mode.
●
Monitoring.
(This is sample case of being installed 2 door cameras & 2 CCTV cameras. If it is not
set like this, camera monitoring function shall not be deactivated.)
1. Press monitoring button ( ), appears camera image for 30 seconds.
2. Monitoring sequence (Screen will be changed by clicking the button in following
sequence below)
1) Camera 1 + CCTV1 (PIP mode)
a. Case 1: In case of no CCTV1 signal, screen will be switched to Camera 2 in
full screen mode.
2) Camera1 (Full screen)
3) CCTV1 (Full screen)
a. In case of no CCTV1 signal, screen will be switched to Camera 4(camera
2+CCTV)
How to operate
4) Camera 2 + CCTV2 (PIP mode)
a. Case1 : In case of jumper pin is set at “CA2_USE”like picture no. 21, screen
will be switched to Standby mode.
b. Case 2 : Incase of no CCTV2 signal, screen will be switched to camera5 in full
screen mode.
5) Camera 2 (Full screen mode)---In case of camera2 & removed jumper pin like
picture no.21
6
