Command Light CL602A, Руководство пользователя, Страница: 18 / 48

COMMAND LIGHT
17
Center Switch Adjustment
Exercise caution when performing the following procedure. There are numerous pinch points that can
cause severe injury. Adjustment should be performed by qualified personnel.
1. Raise lamp tree fully. Raise lower stage enough to comfortably work on. Verify lower stage is above
the safety limit, lamps can be illuminated.
2. Visually inspect the screw on the rotation platform to be sure it is activating the Turck sensor. The
green light on the sensor indicates it has power. The orange light indicates the sensor is activated.
3. Rotate off center. Activate Autopark and let light tower proceed through sequence until the lamp tree
is a couple inches above the nested position, hit Emergency Stop.
4. Visually determine which side the lamp tree will be hitting the nest pad.
5. Raise lower section above safety limit and to comfortable working height.
6. Loosen screws on center switch bracket slightly.
7. Tap center switch bracket slightly toward the side that the lamp tree is hitting on.
8. Fully tighten the screws holding the center switch bracket.
9. Raise lamp tree all the way up, rotate off center.
10. Press the Autopark button and let light tower proceed through sequence until the lamp tree is a couple
inches above the nested position, hit Emergency Stop.
11. If it looks like center is now adjusted properly, raise light tower all the way up one last time and press
Autopark and let it go through the entire sequence.
12. If it is still hitting off center, repeat steps 3-11. If problems adjusting center still persist you may need
to adjust the height on the set screw, or call Command Light at 1-800-797-7974 to order a new switch
part number 065-12884.
1. Visually check to see if the orange indicator light is activating with metal in proximity and that the
green light is on constantly.
2. Check continuity of white/black wire in relay box to the connection point in the box below the mid-
plate. White/black should connect to the black wire from the Turck sensor.
Light Tower is Not Finding Center