User Manual
SW-81VA-2
COMM-TEC GMBH
SIEMENSSTRASSE 14
T49(0)7161/3000-0
WWW.COMM-TEC.DE
D-73066 UHINGEN
T49(0)7161/3000-333
4.0 Attaching Inputs and Outputs and Power Up
a)
Switch all units OFF while attaching the signal cables.
b)
Connect the 8 computer video sources to the 15pin HD female connectors.
c)
Connect the destination to the 15pin HD female connector.
Note:
For the video connections, use good quality 75
Ω
coax cable.
The video outputs can drive a signal up to approx. 20 meter cable length.
For longer cable runs use a signal line driver.
d)
Connect the stereo audio sources to the eight stereo RCA sockets L+R 1 - 8.
e)
Connect the stereo audio output (unbalanced on RCA connectors and/or
balanced on the 5pin screw terminal) to a pair of active speakers, an
amplifier or any other Signal Management unit to process the audio signal.
f)
Connect the unit to a power source as described in chapter 2.0 and set the
switch at the rear side to ON.
Check that the LED in the pushbutton 1 lights up. After the power-up source
#1 is automatically selected. The SW-81VA-2 switches always in the Audio-
follows-Video mode.
5.0 Front Panel Control
The switcher SW-81VA-2 can be controlled by
the 8 pushbuttons on the front panel.
The lighting up of the LED indicates which
source is present on the output.
After the power-up source #1 is automatically
selected.
