www.desatech.com
115006-01C
8
INSTALLATION
Continued
OPTIONAL GA9200 SERIES ON/OFF
SAFETY VALVE/PILOT KIT
For additional convenience and safety an optional
ON/OFF safety valve/pilot kit is available. See
Ac-
cessories
, page 13.
Parts are available in this kit for propane/LP conver
-
sion. See kit instruction sheet for detailed installation
instructions.
WARNING: You must use an
ON/OFF safety valve/pilot kit for
propane/LP conversion.
TESTING BURNER FOR LEAKS
1. Generously apply noncorrosive leak detec
-
tion fluid to all connections.
WARNING: Never check for
gas leaks with open flame.
2. Light the burner with the shutoff valve no
more than half open and holding a match
slightly in front of the pan (see
Lighting
Instructions
, page 9).
3. Inspect all connections for bubbles, raw gas
odor, or flame from any area other than the
burner (leaks). If leaks are detected, shut off
the gas valve immediately. Tighten, or reas
-
semble the loose connection(s) using pipe joint
compound until burner system is leak free.
4. When the burner is tested and leak free, ob
-
serve the individual tongues of flame on the
burner. Make sure that all ports are clear and
producing flame evenly across the burner.
If any ports appear blocked, clear them by
removing the burner manifold and reaming
the ports with a modified paper clip or other
suitable tool.
5. When finished testing, turn the gas shutoff
valve OFF to extinguish all flames.
ADDING PAN MATERIAL
1. Open the bag of glowing embers and spread
it evenly over the burner ramp.
2. Open the small bag of platinum embers and
place them randomly throughout the ember
bed; more heavily near the front of the
ramp.
INSTALLING THE GRATE AND LOGS
1. Place the grate over the burner pan where the
two outer horizontal supports on the grate fit
into the two pan positioning tabs on the outer
edges of the pan.
2. Place the large back log on the grate at the top
tier (rear) of the ramp (see Figure 7).
3. Figure 7 and Figure 8 on page 9 show a recom
-
mended log arrangement, however you may
arrange the logs as you wish. Leave as much
open space between logs as possible to mini
-
mize flame impingement and sooting.
Note:
Logs may chip if they are handled roughly or
if hit together while being placed.
Figure 7 - Installing Logs
Burner Pan
Grate
Pan
Positioning
Tab
Back Log
