COMEX S.A.
CMX: 202023.01 EN
6
Electrical Installation
Step 1. Receptacle evaluation
Ensure that the plug type of your ATS PDU unit matches the receptacles that you are using.
The ATS PDU must be plugged into a three-wire, grounded utility receptacle or a
UPS that is connected to a grounded utility receptacle. The utility receptacle
must also be connected to an appropriate branch circuit/main with fuse or circuit
breaker protection. Connection to any other type of receptacle may result in an
electrocution hazard.
Step 2. Plug the ATS PDU into the utility receptacle and/or UPS.
Step 3. Attach equipment
It is extremely important not to exceed the ATS PDU's maximum current load (as outlined in the
Specifications section). In order to determine total load, use the LCD diaplay on the front of the ATS
PDU to monitor the load being attached.
Network Installation
(Performed when a Power Management Card is installed)
Step 1. Attach the LAN Cable
Using a CAT5 RJ45 cable, attach one end to the Ethernet port on the PMCard, and the other end to a
network port.
Step 2. Establish the ATS PDU IP address
Assigning an IP address to the ATS PDU requires the user to have an available IP address that is valid
on the respective network. If an available IP address is unknown, contact the network administrator
to obtain one. The default IP is 192.168.20.177 and the default for the DHCP function is on.
There are multiple methods for setting up the IP address of the ATS PDU. Please follow the instructions
below for the method that is appropriate for your application.
Please make sure the ATS PDU is powered on during this process.
Option 1 (recommended): Power Device Network Utility
1.
Download the Power Device Network Utility software.
CAUTION !!!
