Comet System T2114, Инструкция по эксплуатации

Страница: 6 / 7

6 IE-SNC-T2114-03
•
Unscrew four screws of the device lid a remove the lid. If device is already installed to
measuring system, disconnect leads from terminals.
•
Connect SP003 communication cable to the device. Display must light up, or at least
must light up all symbols for one second (if LCD was switched OFF by program
before).
•
Run installed TSensor program and select corresponding communication COM port
(as described above).
•
When new setting is saved and finished, disconnect the cable from the device, connect
leads into its terminals and place the lid back to the device.
Error States of the device
Device continuously checks its state during operation. In case error is found LCD displays
corresponding error code:
Error 0
There is a reading „Err0“ on LCD display.
Check sum error of stored setting inside device’s memory. Output value is <3.8 mA. This error
appears if incorrect writing procedure to device’s memory occurred or if damage of calibration data
appeared. At this state device does not measure and calculate values. It is a serious error, contact
distributor of the device to fix.
Error 2
There is a reading „Err2“ on LCD display.
Atmospheric pressure measurement error occurred. Output value is about 3.8 mA. Measured
pressure value
with added correction for altitude is outside of range from 300 hPa to 1350 hPa
(from 4.351 PSI to 19.580 PSI) or the pressure sensor is damaged. Please check setting of pressure
correction for altitude with User’s software.
Error 4
There is a reading „Err4“ on LCD display.
It is internal device error during pressure sensor initialization. Under this condition device does
NOT measure atmospheric pressure Output value is about 3.8 mA. Pressure sensor is probably
damaged. It is a serious error, contact distributor of the device.
End of operation
Device itself (after its life) is necessary to liquidate ecologically!
Technical support and service
Technical support and service is provided by distributor. For contact see warranty certificate