COMENDA Prime PC07, Инструкция по эксплуатации и обслуживанию

Страница: 27 / 104

27
F1
CAPOTE OPEN WARNING
This warning is displayed when the capote is open.
The warning remains displayed until the capote
is closed again.
H3
INSUFFICIENT WASH WATER TEMPERATURE
This alarm is displayed if, during the cycle,
the wash phase is carried out at least 10°C lower
than the set temperature
F2
TANk WATER FILL-UP
This warning is displayed when the machine is
fi lling water (only during the initial fi ll-up phase -
only with the starting temperature control active).
ENGLISH
Part 3: Reserved for the technician
C1
DRAIN and SELF-WASHING CyCLE
This warning is displayed when the machine is
running the SELF-WASHING cycle.
C2
DRAIN CyCLE
This warning is displayed when the machine is
running the DRAIN cycle.
C3
REGENERATION CyCLE
This warning is displayed when the machine is
running the REGENERATION cycle.
NO TANk FILL-UP DURING CyCLES
This alarm is displayed if the tank does not fi ll up to the
pressure switch level during the wash cycles.
The display will show the
set-point temperatures
and the START key
will light up STEADY YELLOW.
The alarm can be reset by turning the machine off
and on by pressing the START key.
START START
3.3 RINSE AGENT LIQUID
DOSAGE with
a HyDRAULIC PUMP (Fig. 8)
Make sure that the suction hose (13) of the rinse agent
is inserted correctly into the tank (12). It will be dosed by
actuating the adjustment screw, which after being fully
closed, must be unscrewed by two complete turns.
3.3.a MACHINES with no RCD
Fill the dispenser hose by turning the machine on by
pressing the "START" key and bring it to the adequate
temperature. Start the washing cycle, and during this
cycle, open and close the capote several times until the
rinse agent has reached the dispenser.
3.3.b RCD MACHINES
Fill the dispenser hose by turning the machine on by
pressing the "START" key without inserting the
overfl ow.
Wait for the boiler to reach the adequate temperature
for the fi rst tank fi ll-up. When the tank starts being fi lled,
open and close the capote several times until the rinse
agent has reached the dispenser. If the rinse agent
has not reached the dispenser, wait for the boiler to be
restored, for the boiler to heat up and then repeat the
previous steps.
3.3.c CHECK PROCEDURE
Once the steps described above have been carried out,
insert the overfl ow for the tank to be fi lled. Then wait for
the machine to reach an adequate temperature ("Green"
or "Flashing green" START key). Then try to wash. If the
washed items have drops, it means that the amount of
rinse agent is too little. If rings appear, it may mean there
is too much rinse agent or excessive water hardness.
The adjustment can vary depending on the type of rinse
agent. At this point, the machine automatically draws
the necessary liquid for each rinse: during the washing
steps, check that the liquid in the container does not run
out.
3.4 DETERGENT LIQUID
DOSAGE (Fig. 8)
(only for machines with an incorporated
dispenser)
Fully close the dispenser adjusting screw, and then
slowly open it until the recommended amount by the
manufacturer is reached. Turn on the machine and wait
for the machine to reach the adequate temperature.
Then run an empty cycle to dose the product.
Check that the correct amount of detergent is drawn dur-
ing the rinse (1 cm = approx. 1g).
F6
HEAT RECOVERy
This message is displayed when the
machine performs the heat recovery cycle
(by means of the CRC).
The report remains until term of the heat recovery cycle