COMENDA Prime PC07, Инструкция по эксплуатации и обслуживанию

Страница: 20 / 104

20
ENGLISH Part 2: Reserved for the operator
2.8. REGENERATION CyCLE
(only for "A" models)
The regeneration phase of the resins must start with
the dishwasher ON, FULL TANk and capote
CLOSED.
2.8.a FILLING THE SALT TANK
First of all make sure that there is salt in the specifi c con-
tainer; otherwise, proceed as follows:
1. Unscrew the cap from the tank and introduce ONLY
COARSE COOKING SALT.
2. Fully screw the cap back on to make sure it is closed
properly
2.8.b STARTING RESIN REGENERATION
Once the cycles set on the display are reached, A9 appears
on the display, which means REGENERATION REQUIRED.
Press the SCROLL
key
Select the C3 function
from the display.
Press the START key.
The START key turns
WHITE.
Open the capote.
Remove the overfl ow (13) and close the capote again.
The REGENERATION phase begins.
When the cycle has begun, the display on the right will read C3.
If the tank is not drained, the alarm A10 will appear on the
display at the end of the cycle.
ATTENTION
F1 appears if the capote is opened during the
regeneration
The regeneration cycle is interrupted and then resumes
when the capote is closed.
At the end of the cycle, the machine switches off
automatically and the display reads OFF.
The machine is now ready for use.
START START
ATTENTION
Pressing the START key for 5 sec. with the
REGENERATION cycle in progress, the cycle
is immediately interrupted, the dishwasher is-
switched off and OFF appears on the display.
If regeneration is interrupted it does not allow the indicated
REGENERATION REQUIRED to be eliminated (alarm A9
on the display), which will reappear upon the next switch-on.
IMPORTANT
Upon switch-on, after an interrupted regeneration,
wait for the tank to be restored until the START key
becomes STEADy GREEN or FLASHING GREEN.
Run a complete SELF-WASHING cycle
by performing the following steps:
START START
START START
Press the SCROLL
key.
Select the
C1 function on the display.
To start the cycle, press the
START key.
At the end of the SELF-
WASHING cycle the dishwasher
switches off and OFF will
appear on the display.
START START
The machine can be reused by re-inserting the overfl ow
in its original position and switching the dishwasher on.
Due to the interrupted regeneration, alarm A9 will remain
on the display.
We recommend starting a regeneration cycle as soon as
possible.
START START