9
1 MENU SETTINGS
After the machine is installed and powered on, the PTZ camera will be self-checked, and the screen will display boot
information, as shown in Figure 1-0-0.
Display PTZ camera address
Display protocol recognition method
Display baud rate recognition method
Figure1-0-0
Explanation:
When the PTZ camera is set up differently, the specific values of each item will also be different. This prompt will
disappear until the PTZ camera has completed self-examination. Note: Only when the system display function is turned on in the
menu, will display the boot information.
Enter the main menu:
Set the 95 preset point first and then calling the 95 preset point. At this time, the screen shows the main
menu, as shown in Figure 1-0-1.
SYSTEM INFORMATION
→
(Figure1-1-1)
MOTION SETUP
→
(Figure1-2-1)
CAMERA SETUP
→
(Figure1-3-1)
USER ADMIN
→
(Figure1-4-1)
SYSTEM
SETUP
→
(Figure1-5-1)
Figure1-0-1
1.1 SYSTEM INFORMATION
In the menu of Figure 1-0-1, move the rocker up and down so that the cursor points to the system information, and then move the
rocker to the right to display the system information menu, as shown in Figure 1-1-1.
Display PTZ camera address
Display communication protocol
Display communication baud rate
Display PT version
Figure 1-1-1
Description:
The arbitrary movement of the rocker to exit sys information display.
ADDRESS 255
COMMUNICATION PROTOCOL PELCO-D
BAUD RATE 9600
MAIN MENU
SYSTEM INFORMATION
MOTION SETUP
CAMERA SETUP
USER ADMIN
SYSTEM
SETUP
EXIT
ADDRESS
0
PROTOCOL PELCO-D
BAUD RATE 2400
PT VERSION V1.10
