Comco 523 Series, Инструкция по установке и эксплуатации

Страница: 30 / 39

29
ComCo Systems Inc. | 800.533.3794 | www.comcosystems.com
500508 Rev. A
523
Series
Theory of Operation
Powering the System
The rocker switch at the top of the teller unit control panel controls power to the system. The adjacent red
LED indicates “power on.”
NOTE : The power switch does not switch off 120VAC service to any component. It is only used
to deactivate the system. Some components may remain energized and/or active when the system
is “off.”
Power ON
1.Teller switches power on
2.Power indicator illuminates
3.If the teller unit door is closed when the unit is powered on the system will start an auto-send cycle.
(If this is not desired it is best to leave the teller unit door closed before power the system down)
4. CVM Systems only: Camera and monitor in CVM are powered on
5.System is now in ready state
Power OFF
1. Teller switches power off
2. Power indicator extinguishes
3. Customer Unit door closes
4. CVM Systems only: Camera and monitor in CVM are powered off
5. System is now off
The power switch may be used to recover from unusual system conditions simply by switching it off and
on – this will reset the system.
Send cycle
1. Teller inserts carrier into teller unit
2. Teller is recommended to close the teller unit door and presses SEND
3. Send cycle begins
4. Vacuum blower activates
5. The valve in the Teller Unit opens releasing the catch mechanism carrier into the transmission tube
below the unit
6. Carrier is propelled from Teller Unit into transmission tubing towards Customer Unit
7. Carrier arrives at Customer Unit
8. Vacuum blower deactivates
9. Customer Unit door opens
10. Send cycle ends; System is now in ready state
Operation