CombiSteel 7486.0055, Руководство пользователя

Страница: 5 / 22

5
www.combisteel.com
5. Maintenance
Regular maintenance of the appliance is to be performed by the user by means of:
- Washing the appliance periodically with warm water and washing agents adequate for washing dishes. In order
to clean the area where the glass pane touches the sidewall, remove the grips holding the side glass pane.
After cleaning mount the elements back in a reversed order. When removing and mounting the elements back,
exercise special care. Never use sharp instruments to remove dirt from the Counter's inside or outside surfaces.
IMPORTANT! While washing the appliance, never leave the front glass pane tilting freely on the hinges. The
glass pane may break on such an occasion, which is not subject to warranty. Never use cleaning agents
containing chlorine or any other aggressive chemicals.
- Cleaning the condenser in the refrigerating unit's chamber. First you need to remove the shield of the
refrigerating unit's chamber. The condenser must be cleaned every three months by means of a hard brush and
a vacuum cleaner. If the condenser gets very dirty in quicker time, perform the cleaning more often. Dirty
condenser may result in overheating of the refrigerating unit and subsequently the appliance's failure that is not
subject to warranty.
- Replacing the fluorescent lamp. First remove the lamp's shield and then turn it by 90° and slide away from the
grips. Replace the fluorescent lamp with an identical one. Reverse the above steps to mount the elements back.
IMPORTANT: The appliance must be disconnected from the power supply (remove the feeder cable from the
electrical socket), before the washing, condenser cleaning and fluorescent lamp replacement operations are
started.
The condenser should be cleaned at least once a month!
6. Safety at work rules
- On no account connect the appliance to power supply without the grounding protection.
- The electrical installation must be performed by an authorized electrician.
- Any repairs or adjustments in the electrical or cooling circuit may be performed exclusively by an authorized
wireman.
- In the event any failures or defects are determined, such as sparking, breakdown, etc., disconnect the appliance
from the power supply by removing the feeder cable's plug from the electrical socket and consult an electrician
for a remedy.
- If the feeder cable needs replacing, the new one must be of the same type. The operation must be performed
by an authorized electrician.
- Wash and clean the appliance only when it is disconnected from the power supply.
- Remember to clean the condenser and empty the drip container regularly
Do not:
- Fill the Confectionery Display Counter with goods before it cools down.
- Overload the CDC with excessive volume and weight of goods.
- Fill the CDC with warm or hot products.
Note: The used-up elements discard in compliance with applicable regulations.