CombiSteel 7478,0130, Инструкция по эксплуатации

Страница: 8 / 49

8/49
Be sure that in electrical operated devices, the electricity current has been supplied in adequate features as stated in TECHNICAL DATA
catalogue and grounding connection has been complemented. .
Read the instruction and maintenance manual absolutely.
FINAL CHECK BEFORE START UP
o
The users should fulfill the following last-controls by accepting the required couplings of fresh water, electric, wastewater ,
installations to be carried out by the authorized technicians;
o
You must be sure that the power supply and grounding installation are ensured as required in leaflets of electrical equipment.
o
You must be sure that the feeding water has been installed and the water vane is turned on.
o
You must be sure that the wastewater installation was done properly and discharging hose was coupled with discharging pipe tightly.
10. START UP
The figures of control panel on the devices have been shown. According to these figures, as earlier mentioned, the device, whose
electrical connection was made fully and correctly, is operated by turning on control switches.
In the models with double housing, the control switches of the section, where cooking operation will be performed, must be opened.
Thermostat control switch for 135-180° C is set to desired temperature.
When the thermostat yellow singnal lamp lights off, it means that the heater has reached desired temperature .
While the devices are in operation, do not keep burning material (plastic bags, table napkin, clothe etc.) near them.
Fried materials, in order to filter their oil, are kept putting them into baskets fixed to the basket hanging places.
When the heaters are taken out from their places, heating operation stops automatically. While the device is in active, heaters must
not be taken out in any way.
According to the sort of fried material, oil must be filtered in intervals or before beginning the frying operation. In the cupboard of
the device, there is oil filtering and housing and a filter. Oil filtering housing is placed in such a way that it should be under the
drainage valve. Then, opening slowly the valve, oil is filtered. Filtering operation must be performed, while the oil is cool. Pouring the
flittered oil into the oil pool, frying operation can be repeated.
If the oil in the electric deep fryer is in the condition not to be used, waste oil must be removed out, not harming to the environment.
Oil filtering operation must be done in short intervals very definitely. Otherwise, oil can turn into the conditions harming the health.
It is not recommended to fry different materials in the same oil.
Do not operate the device out of the liquid levels which are mentioned on the table
After using the device, bring all control switches in to “0” position and switch of f electric energy.
While device is in operation, the device, heater, top side and front panels reach to high temperature. Do not touch these parts in no
way.