COMBA mBDA OD Series, Руководство пользователя

Страница: 26 / 52

INSTALLATION GUIDE FOR mBDA OD SERIES
ENU STATUS : 1-0-0 Copyright - refer to title page Page 26
Table 6: Combiner Connectors
Identifier Descriptions
DT N-Female connector for connection to donor antenna
MT N-Female connector for connection to service antenna
DT with
frequency N-Female, connect to mBDA DT port; the combiner DT frequency range need
cover the connected mBDA frequency.
MT with
frequency N-Female, connect to mBDA MT port; the combiner MT frequency range need
cover the connected mBDA frequency.
3.4.3 GROUNDING CONNECTION
Ground Connection
To ensure safe operation of the product, a ground (earth) connection is required. For single phase AC
power
source, the product must be grounded by connecting the “earth wire” of the power cord to the ground
terminal of the AC supply. For operating this product with DC power system (such as rectifiers), the product
should not be connected to power systems that switch open the return lead because the return lead could
function as the ground (earth) connection for the equipment.
Protective Ground Connection
The enclosure must be grounded securely by connecting a copper wire (CSA 16mm
2
) to the grounding
terminal on the equipment/rack, and the other end to a protective ground (i.e. building earth point). An
internationally acceptable colour code of the ground connection wire is green/yellow.
Such a ground connection implements the “Protective Ground Connection”, and must be connected to the
equipment at the designated ground point. In general, do not connect the supply before establishing an
adequate ground (earth) connection.
Construct the ground wire, and use appropriate crimp connectors where necessary. Locate and connect the
equipment grounding terminal to a protective ground (i.e. building earth point).
3.4.4 RF CABLE CONNECTION
Single band mBDA RF cables connection is as follows:

mBDA MT port or Combiner MT port

Connects to the feeder cable from service antenna.

mBDA DT port or Combiner DT port

Connects to the feeder cable from donor antenna.
Dual band mBDA RF cables connection is as shown in the following figure.