InteliVision 18Touch 1.0 Global Guide
22
6.1.2 USB connection
Image 6.2 Point to point USB connection
IV18T settings
Controller settings
3 x USB serial ports (3x rear) No special settings required
No special settings required.
Some controllers only via ext. bridge.
Table 6.2 Communication settings for the IV18T and controller
Note:
Direct USB connection is not possible for some controllers. However, USB connection is available for all
above-mentioned controllers via I-LB+ or IB-NT (see the chapter Connection via I-LB+ or IB-NT)
6.1.3 Ethernet (direct) connection
Many different kinds of Ethernet topologies exist. A basic point to point Ethernet connection can be made by a
direct or cross Ethernet cable. In addition, it is also possible to monitor more than one controller in a site through
a switch (TCP/IP protocol-based network). Another possibility is establishing a connection through the internet
network, but for this a public IP address is necessary (or AirGate ComAp technology without a need for a public
IP address). The physical configuration of such a network can be a small Ethernet LAN or also through the
internet.
Image 6.3 Point to point Ethernet connection
