Accessory Modules for IL-NT, IC-NT, IA-NT and ID-Lite Global Guide
14
4.1.4 LEDs indication
LED
Description
State
RxC
No data are received on the CAN line
Dark
Data are received on the CAN line
Blink
TxC
No data are transmitted on the CAN line
Dark
Data are transmitted on the CAN line
Blink
RxD
No data are received on the RS232 or RS485 line
Dark
Data are received on the RS232 or RS485 line
Blink
TxD
No data are transmitted on the RS232 or RS485 line
Dark
Data are transmitted on the RS232 or RS485 line
Blink
TxUSB
No data are received on USB
Dark
Data are received on USB
Blink
RxUSB
No data are transmitted on USB
Dark
Data are transmitted on USB
Blink
RUN
No power supply
Dark
Power supply OK
Continuous light
PWR
When at least one controller is active on the CAN bus
Continuous light
After connection power supply - no controller detected on the CAN bus
(during communication speed detection).
Blink
4.1.5 Wiring
I-LB+ has to be connected to modem via standard modem cable (full RS232) where the DSR (Data Set
Ready) signal detects modem presence (when MODEM (HW) type selected). Three-wire RS232 cable (TxD,
RxD, GND) can be used (e.g. for GSM modems) when MODEM (SW) type is selected.
