COM-power corporation ARI-6000-100W, Инструкция по эксплуатации

Страница: 24 / 42

Page 24 of 42
INSTRUCTION MANUAL
ARI-6000-100W RF Power Amplifier
SECTI ON 5
- OPERATION
1912 1 E l T o ro R d ● Si l vera do, Ca lifo rni a 9 26 76 ● (9 49) 459 -96 00 ● co m-p o wer. com
REV011718
Item Description Comments
Gain (VVA) Level
(Read Only in Run Mode) Gain: XXX.X% When the unit is in ALC mode this
value will change dynamically as the
input signal changes.
When the unit is in VVA mode this
value should mirror the value set in the
Output Level Set display.
User can change either VVA or ALC
level by using the
↑ and ↓ keys on the
panel after first pushing the ‘ALC’ or
‘GAIN’ buttons.
Monitors
(Read Only in Run Mode) I1: X.X I2: X.X
I3: X.X I4: X.X
or
V1: X.X V2: X.X
V3: X.X V4: X.X
Any combination of V and I
monitors are possible. Displays the voltage and/or current
monitors. They are displayed four at a
time; pressing the mode button
advances to the next set of four. After
all of the monitors are displayed,
pressing the mode button advances it
to the next display. If no monitors are
configured, this mode is skipped.
GPIB Address
(Read Only in Run Mode) Address = XX
Where
XX = 1 to 31
Default is 5 Displays the GPIB / IEEE-488 device
address of the Amplifier.
Valid address values are from 1 to 31.
This menu item will not appear if the
GPIB Interface has been disabled in
the System Calibration Options.
Version X.YY
Where
X = Revision number, and
YY = Version number Displays the Revision and Version
number of the Front Panel Controller
firmware.
Fault Display Temp and/or Fwd Pwr
and/or Rev Pwr
and/or In Pwr
and/or VSWR and/or Mon x
and/or ALC Range
and/or EXT. VSWR Displays any acknowledged
notification faults. If no minor faults
have occurred, these items will not
displayed and this menu item is
skipped.