Columbia 26J, Руководство оператора

Страница: 12 / 36

12 S
ection
3— A
SSembly
& S
et
-U
p
4. Position the seat assembly in place over the seat mounting
bracket aligning the holes provided. Secure with shoulder
bolts and locknuts bolts previously removed. See Figure
3-7.
Note: Make sure that the bolt’s shoulder is completely
recessed into the seat bracket when securing the lock nut.
5. To adjust the position of the seat, loosen the adjustment
knob/bolt on the bottom of the seat. Slide the seat forward
or backward as desired. Retighten the adjustment knob/
bolt. Refer to Figure 3-7.
Installing The Deck Chute
WARNING!
NEVER operate this tractor without
either the mulch plug or deck chute installed.
1. Remove the wing knobs installed on the mowing deck and
retain for later installation.
2. Install the deck chute into the deck discharge opening on
the deck. The studs on the deck surface will fit through the
holes on the upper portion of the deck chute. The small tab
on the deck lip area will fit through the square cutout on
the lower portion of the deck chute. See Figure 3-8.
Note: Make certain that the upper-rear portion of deck
chute is depressing the safety switch located on the deck
surface. The engine will not start without the deck chute
properly in place.
3. Secure the deck chute by tightening the wing knobs
removed earlier. See Figure 3-8.
Install The Rear Engine Cover
1. Remove the two factory installed hex screws located on the
rear engine cover. Retain the screws for later instructions.
See Figure 3-9.
2. Install the rear engine cover by positioning it in place as
shown in Figure 3-9. Tip the engine cover forward to fit it
into the slots provided, then rotate it backwards to align
the mounting holes.
3. Secure the cover with the two hex screws previously
removed. Do not to over-tighten.
Figure 3-8
Figure 3-9
1
2
Adjustment knob/
bolt
Figure 3-7
12