19
www.colormetrics.info
Color
metrics P1000
19
5-4. VFD / 8”or 10” 2
nd
Display
1. Remove top cover.
2. Either plug the VFD cable into the VFD connector or plug the 8” or 10” 2
nd
display cable into the
2
nd
display’s connector (note: display connector can only be connected to one device at a time).
3. Install VFD with 2 screws / Install 8”or 10”2nd display with 2 screws.
1
2
3
20
6-1. MagSwipe Card Reader Configuration Utility
The MagSwipe Configuration Utility is used to set up the output format of MagSwipe
CIDTestAp V07.01 Operation Manual
1. Device Connection
2. Utility Features
3. Configuration Setup
Version: V01.00 .
1. Device Connection
1. USB(HID) Interface
Select the USB HID device which has been plug into the PC USB port, enter the
correct Vendor ID = 0E6A and Device ID then press ‘OK”, different device has its
own Device ID., e.g. DID=0x030F for keyboard and HID USB, DID=0x5082 for
keyboard, HID and VCP USB.
2. Utility Features
After success device connection each supported command will get its response, e.g.
Get Version command should response with the device HW/FW version, for all
command set supported please reference its programming guide.
There are two command/response windows can be used (see block1 & 2).
For second level device the Indirect command signal should be selected (see block3 & 4). Press
Device
Driver Installation
6
DEVICE DRIVER INSTALLATION
2. Utility Features
After success device connection each supported command will get its response, e.g.
Get Version command should response with the device HW/FW version, for all command set
supported please reference its programming guide.There are two command/response windows
can be used (see block1 & 2).
For second level device the Indirect command signal should be selected (see block3 & 4).
