manufacturer and may cause fire, electric shock or injury.
Do not use abrasive cleaning products on this appliance. Clean with a damp cloth (not wet) rinsed in
hot soapy water only. Always remove plug from the mains supply before cleaning.
The heater must be installed at least 1.8 m above the floor.
The heater must not be located immediately below a socket-outlet. Socket-outlet should not be located
at the back of the heater. They should be located outside the physical footprint of the units to minimize
heat build-up behind the heater. The installation must be equipped with an all-pole disconnection
mechanism with a break contact distance of at least 3mm. The All-pole disconnection mechanism
must be installed on the height less than 1.8m from the floor.
The heater is to be installed so that switches and other controls cannot be touched by a person in the
bath or shower.
If the heater is to be mounted on an incline (eg. Vaulted ceiling), ensure the electrical connection is
located at that lowest point of the heater.
Do not connect the appliance to the mains source until it has been installed in its final location and
adjusted to the position it will be used in.
Do not operate with the cord coiled up as this could cause a build up of heat, which could pose a
hazard.
The use of an extension cord with this appliance is not recommended.
Do not allow cord to come in contact with heated surfaces during operation.
Do not run cord under carpeting, throw rugs or runners etc. Arrange cord away from areas where it is
likely to be tripped over.
Children and persons with reduced physical, sensory or mental capabilities or lack of experience and
knowledge are not allowed to use the appliance unless they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards involved. Children shall not
play with the appliance. Cleaning and user maintenance shall not be made by children without
supervision.
The appliance is only intended for the purpose described in user manual.
Do not use appliance or any part of the appliance out of the intended use to avoid risk.
The use of attachments which are not recommended or sold by the appliance manufacturer may
cause a risk of injury to persons
CAUTION
— some parts of this product can become very hot and cause burns. Particular attention
has to be given where children and vulnerable people are present.
Install and operate the heater in strictly horizontal position on the ceiling or ceiling structural elements.
At that, thermal resistance of the ceiling coating material should be at least 80 °C.
WARNING:
This heater is not equipped with a device to control the room temperature. Do not use this
heater in small rooms when they are occupied by persons not capable of leaving the room on their
own, unless constant supervision is provided.
