NOTE:
Depending on the material and the design of ceiling structural elements, the heater is secured onto
appropriate fasteners chosen on basis of the strength condition. Strength of the ceiling or structural
elements, to which the heater is secured, should be sufficient to endure 5-fold weight of the heater.
Connection to electric mains
After installation of the heater and before switching for the first time, it is necessary to wipe the radiating
board with alcohol. After that, it is PROHIBITED to touch the radiating board.
The heater is designed for connection to the single-phase 230V~ 50HZ electric mains equipped with a
grounding loop.
Before connection, make sure that specifications of the electric mains at the connection point meet the
parameters indicated on the appliance nameplate.
Models CLHR-150A, CLHR-180A και CLHR-240A with plug to connect to supply mains, and model
CLHR-320A is fixed wiring.
For the model CLHR-150A, CLHR-180A και CLHR-240A: The electric mains should be equipped with
an automatic circuit breaker with rated current not less than 16A and height less than 1.8m from the
floor..
For the model CLHR-320A: For disconnection must be incorporated in the fixed wiring in accordance
with the wiring rules. The installation must be equipped with an all-pole disconnection mechanism with
a break contact distance of at least 3mm. The All-pole disconnection mechanism must be installed on
the easily pull out and insert to the plugs by persons and height less than 1.8m from the floor.
The heater must not be located immediately below a socket-outlet. Socket-outlet should not be located
at the back of the heater. They should be located outside the physical footprint of the units to minimize
heat build-up behind the heater.
If the heater is to be mounted on an incline (eg. Vaulted ceiling), ensure the electrical connection is
located at that lowest point of the heater
.
MAINTENANCE
Any maintenance should only be carried out by a qualified electrician.
During operation, it is necessary to periodically (once a year) check the electric cable contacts and
terminal connectors for good tightening.
If the body becomes dirty, wipe off dust with a towel. Radiating boards should be wiped in cold
condition with alcohol.
NOTE:
Radiating boards should be wiped with a soft rag moistened in alcohol leaving no scratches on the
surface. Use of other liquids is prohibited!
WARNING!
Never immerse the appliance in water! Danger to life!
