Physical Details
The physical connections and switches are on the left side of the
front panel.
Inputs Used
Plug the devices providing the input into the proper connector(s) on
the front panel:
Start System
Plug the launch pad into the Start System jack.
Touchpads
There are two touchpad inputs. Plug the finish pad into either of
them. The touchpad inputs are connected to the same internal signal,
so it makes no difference which one is used.
Reset / Breakout
Plug a pushbutton into the Reset / Breakout jack to use for resetting
the clock (optional for Speed Timer mode, required for Five Minute
Countdown).
Scoreboard/Training
The Scoreboard/Training switch is not used on the Counting Clock
Pro. It can be set to either position.
Battery
The internal battery can supply power to the pace clock. A fully
charged battery will run the unit for a minimum of 6 hours. Leave
the unit plugged in overnight to fully charge the battery after use.
The battery charges any time the unit is plugged in to AC power.
Horn
The internal horn will sound at the end of the Five Minute Count-
down, for one second.
Legs
The clock includes legs. If you would like to use the legs, attach
them with the hardware included to the threaded mounting holes in
the bottom of the clock.
AC Power
connection
The power receptacle is on the right end of the clock. It accepts a
standard power cord for 110 VAC. If 220 VAC is required, the
power supply can be modified at the factory. Modified units are la-
beled accordingly.
Introduction
2
