1
Introduction
Thank you for purchasing a Colorado Time Systems Counting Clock
Pro.
Introduction
This introductory chapter describes physical features of your clock.
Subsequent chapters describe how to set up and use your Counting
Clock Pro.
Counting Clock Operation
Chapter 2 describes how to physically set up and use the Counting
Clock.
How to Set Intensity
and Mode
Use the Mode switch on the front panel to set intensity and mode, as
follows:
Intensity
When a Counting Clock Pro is turned on, all digits will light and
then the clock will display
in
and a number for Intensity. While
in
is
displayed, the Mode switch adjusts the intensity of the display. Fif-
teen levels of intensity are available, from 1 (lowest) to 15/16 (high-
est). Select the desired intensity.
NOTE:
The initial intensity displayed will be the last setting saved
before the clock was turned off. It will not change until the knob is
turned for the first time.
Mode
After the Mode switch has been in the same intensity setting for 4
seconds, the clock will display the firmware revision, and then the
current mode. At this point, the Mode switch changes the mode (and
only the mode) until the clock is turned off and then on again.
Introduction
1
