COLO COLO-660, Руководство по эксплуатации

Страница: 6 / 13

6
- -INSTALLATION
→
Propery ground all equipment in the spray area to an earth ground and maintain this ground
→
Remove all containers of volatiles from the spray area
→
Establish and maintain a grounded area for the spray operator
→
The gun of x series must be connect to x control unit
→
OPERATION
→
The operator should hold the gun in his bare hand
→
If gloves are worm ,the palm should be out to assure skin to metal contact
→
The operator should wear shoes with conductive shoes e.g leather
Rubber shoes are not conductive .
→
Ground the tip of the gun before cleaning or changing nozzles.
→
When the gun is not in use , it should be hung so that the nozzle is within four inches of a grounded
conductor
→
The operator should wear a filter-type respiator anytime he is exposed to dusty condit
i
ons
→
High pressure powder many cause injury ,Keep the rear switch
“
off
”
position in no –use condiction
→
MAINTENANCE
→
Make a periodic confirmation of grounding to earh of all equipment in the spray area .
→
Exercise good housekeeping practices , do not allow dirt or powder to accumulate on the feeder
/powder unit , cable or gun.
→
Keep the cabinet door
PERSONNEL
→
Use saop and water to remove powder from the skin washing with solvents can cause reactions
resulting in allergies and disourders.
→
Wash hands before eating and smoking.
→
Do not use compressed air to blow poder off the hands and clothing.
This practice may result in damage to the ear drums or eyes.
2. INSTALLATION
→
Connects the control units MAIN AIR to MAIN AIR(REGULATOR) output unit with air hose
→
Connects the control unit DOSING AIR to INJECTOR with air hose
→
Connects the FLUIDIZING AIR (REGULATOR )output unit to HOPPER with air hose
→
Connects the control unit AUXILIARY AIR to GUN with air hose
→
Connects the POWDER HOSE to INJECTOR
→
Connects the GUN CABLE to CONTROL UNIT with air hose
→
Connects ground connection cable from ground nut to the booth and trolly
→
Connect main powder cable