8
CAUTION
If s
ide burner fails to light immediately, turn burner control knobs “OFF” and wait 5 minutes before
re-lighting with a match
Match lighting the Side Burner / Sear Stove
(if applicable)
1. Open the side burner lid
2. Check that the side burner valve is turned “OFF”.
3. Turn the LP tank valve ON slowly (turn counter clockwise).
Wait for pressure to stabilize for 5 seconds.
4. Put match in a match holder and strike match
5. Push down and turn the side burner control valve to MAX ( ).
6. Hold match holder and lit match by left side of side burner.
CAUTION
If ignition does NOT occur in 5 seconds, turn the burner controls “OFF”, wait 5 minutes and
repeat
the lighting procedure. If the burner does not ignite with the valve open, gas will continue to
flow out of the burner and could accidentally ignite with risk of injury. Turn controls and gas
source “OFF” when not in use.
IMPORTANT
If you have a Co
leman® Even Heat™ Dual Fuel Barbecue, consult the Charcoal Guide for
charcoal lighting instructio
ns.
ATTENTION
Always preheat barbecue before starting to cook. Light all burners and adjust them to the MAX
position for 5 to 10 minutes with the lid closed. Following preheat; adjust the controls to medium
setting for most cooking requirements.
To EXTINGUISH
1. Push in and turn each burner control knob clockwise to the “OFF” position.
2. Turn off the LP Cylinder valve by turning the hand wheel in a clockwise direction until it stops.
WARNING
If the heat output is too low, the “Flow Limiting Device” may have been activated by a gas leak or
improper lighting procedure. If so, turn “OFF” the burner valve and cylinder valve, and perform
a “Leak Test”. If there are no leaks, perform a complete regulator Flow Limiting Device reset.
Sear Stove
*Models may not be exactly as shown.
Side Burner
